Das Commands And Message; Table 5-20: Rs-232 D - Teledyne 200A Instruction Manual

Teledyne API Model 200A NO
The following is a summary of the Diagnostic commands.
Table 5-20: RS-232 Diagnostic Command Summary
Command
D [id] LIST
D [id] name=value
D [id] LIST NAMES
D [id] ENTER SIG
D [id] ENTER OT
D [id] ENTER ET
D [id] EXIT
D [id] RESET
D [id] RESET RAM
D [id] RESET EEPROM

5.5.7 DAS Commands and Message

The M200A contains a flexible and powerful built in data acquisition system (DAS) that enables
the analyzer to store concentration data as well as diagnostic parameters in its battery backed
memory. This information can be printed out through the RS-232 port. The diagnostic data can
be used for performing "Predictive Diagnostics" and trending to determine when maintenance
and servicing will be required.
To print out the properties of all of the data channels enter:
D PRINT
To print the properties of just a single data channel enter:
D PRINT "name"
For example to print the properties of the CONC data channel enter:
D PRINT "CONC"
Analyzer Instruction Manual, 02246, Rev. F1
X
Description
Prints all I/O signal values. See Table 9-4 for Sig I/O definitions.
Examines or sets I/O signal. For a list of signal names see Table 9-4 in
Section 9. Must issue D ENTER SIG command before using this
command.
Prints names of all diagnostic tests.
Executes SIGNAL I/O diagnostic test.
Executes Optic Test diagnostic test.
Executes Elect Test diagnostic test.
Example of Ozone Generator diagnostic is in Section 9.3.6.
Use D EXIT to leave these diagnostic modes.
Must use this command to exit SIG, ET or OT Diagnostic modes.
Resets analyzer software (same as power on).
Resets analyzer software and erases RAM. Erases NO, NO
values. Keeps setup variables and calibration. (same as installing new
software version).
Resets analyzer software and erases RAM and EEPROM. Returns all
setup variables to factory defaults, resets calibration, AutoZero values.
5-37
, NO conc
x 2