Opening Or Closing The Shutter; Changing The Orientation Of The Projected Image - Christie CP2309-RGB User Manual

Opening or closing the shutter

Open the shutter (douser) to display light on the screen, or close the shutter to remove light from the
screen.
• In the right toolbar, select and hold Shutter.
If the shutter was closed, the shutter opens.
If the shutter was open, the shutter closes.
The shutter sensor prevents light source activation when the shutter is closed.
In a situation where the shutter is not functioning, you can use the option for Permit light
source activation when shutter is nonfunctional to permit activation of the light source. To
enable this option, select Service Setup > Preferences > Lens/ILS and enable Permit light
source activation when shutter is nonfunctional.
To avoid damage to the projector, only enable this option when the shutter can be verified as
open.

Changing the orientation of the projected image

Change the orientation of the projected image from normal to inverted to support multi-projector
installations where deflection mirrors are used.
1. In the left navigation menu, select Service Setup > Preferences.
2. Select General.
3. From the Projected Image Orientation list, select the required orientation for the projected
image.
Orientation
Normal Front
Inverted Front
Normal Rear
Inverted Rear
CP2309-RGB User Guide
020-103081-02 Rev. 1 (03-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Description
Projection from behind the audience with the projector in the normal, upright
position.
Projection from behind the audience with the projector in an inverted position
(upside down).
Inverted positioning is not supported for CP2309-RGB projectors. For
more information, see the CP2309-RGB Installation and Setup Guide
(P/N: 020-103078-XX).
Projection from behind the screen with the projector in the normal, upright position.
Projection from behind the screen with the projector in an inverted position (upside
down).
Inverted positioning is not supported for CP2309-RGB projectors. For
more information, see the CP2309-RGB Installation and Setup Guide
(P/N: 020-103078-XX).
Operating the projector
21