Jnior Actions; Dolby Cinema Processor Actions - Christie CP2309-RGB User Manual

Command Description
Set All LEDs Sets values for all of the LEDs

JNIOR actions

These are the available built-in commands for JNIOR devices:
Command Description
Open Relay Opens a specific JNIOR relay
Close Relay Closes a specific JNIOR relay
Pulse Relay Sends a pulse to a specific JNIOR relay for the specified time (in milliseconds)
Execute Macro Executes a JNIOR macro
You can create macros on the JNIOR device and call them using the Execute Macro command. Make
sure you use \\0D for a carriage return and \\0A for a line feed.
To create and run macros on the JNIOR, use the JNIOR Support Tool to enable and configure the
Cinema.JNIOR application. It is recommended that you install Cinema.JNIOR version 2.22.1115.1501
or later. For additional information, see INTEG Process Group (www.integpg.com). Port 9200 is the
default Ethernet port for sending automation commands to the JNIOR.

Dolby Cinema processor actions

These are the available built-in commands for Dolby CP650, CP750, and CP850 devices:
Command
Mute On/Mute Off
Set Format (CP650 only)
Set Fader Level
Send Message (CP850
only)
If you need to control additional functions and a built-in command is not available, send a command
string in a macro. For example, send this command to enable surround boost on the Dolby CP750:
cp750.sys.surround_boost 1\\0D
Make sure that you include a carriage return (\\0D) at the end of each command. For more
information about controlling other features with serial commands, see the Dolby CP750
documentation.
The default Ethernet port for sending automation commands to the Dolby CP650 is port 61412. For
Dolby CP750 and CP850, the default Ethernet port is port 61408.
CP2309-RGB User Guide
020-103081-02 Rev. 1 (03-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Description
Enables or disables muting
Selects the format
Sets the fader level
Sends the specified message
Automation
77