Table of Contents
Advertisement
Preface
This manual describes the LT160 magnetic tape library.
This manual first provides an overview of the tape library and then detailed information
about the tape library. The detailed information includes specifications, installation
requirements and procedures for incorporating the tape library into a system, and
information about how to clean the tape library.
The manual is intended for users who have a basic knowledge of magnetic tape libraries
and how they are used in computer systems.
The organization of manuals related to the LT160 tape library and the scope of this
manual are indicated in the Manual Set section later. Refer to related manuals as
necessary.
The organization and contents of this manual are explained below. This information is
followed by important information related to handling of the LT160.
Organization of This Manual
This manual consists of seven chapters.
Chapter 1 Overview
Chapter 1 explains the library operating environments and where information about each
environment is to be found in this manual.
Chapter 2 Setting Up the Tape Library
Chapter 2 explains how to set the library functions.
Chapter 3 Setting the Fibre Channel Interface
Chapter 3 provides examples of Fibre Channel interface connection. The chapter also
explains how to connect the host interface and drive interface and how to perform zoning.
Chapter 4 Setting the Operating System
Chapter 4 explains how to set the Solaris and Windows NT 4.0/Windows 2000 operating
systems.
Chapter 5 Setting Backup Software
Chapter 5 explains how to set VERITAS NetBackup, Legato NetWorker, and BrightStor
ARCserve2000 backup software.
Chapter 6 Tuning Backup Performance
Chapter 6 explains how to tune VERITAS NetBackup (running on Solaris and Windows
NT 4.0/Windows 2000), Legato NetWorker, and BrightStor ARCserve2000.
C144-E073-01EN
i
Advertisement
Table of Contents
