Notes On Operation - Fujitsu ETERNUS LT160 Setup Manual

•
•
•
5.1.6

Notes on operation

(1) If backup and restore are executed simultaneously, either backup or restore may not
(2) When a volume is added, only one cartridge in cell #1 of magazine #0 is loaded.
(3) Eject Volume From Robot of the GUI can eject only one medium even if more than
Notes:
1.
2.
C144-E073-01EN
Under Solaris 8, the following three parameters are not used; therefore, the settings
are not required.
msgsys:msginfo_msgssz
msgsys:msginfo_msgmap
msgsys:msginfo_msgseg
If another application such as Oracle runs on the system, the setting value may need
to be incremented. However, "shmsys:shminfo_shmmin" must always be 1.
If the system is overloaded when a NetBackup job is being executed, an interprocess
communication error may occur, causing a job error. For example, even though the
volume manager daemon (vmd) is operating, the following message is output and the
job terminates abnormally.
"Media Manager volume daemon (vmd) is not active"
In such cases, review the related system parameters.
end normally. Execute restore after backup is completed.
If either backup or restore did not end normally, take the following actions:
1) Kill the job for which backup or restore did not end normally from the Activity
monitor of NetBackup.
2) If a tape has been loaded in the drive, unload the tape forcibly using Manual
Eject on the LT160 operator panel. For information about Manual Eject, refer to
the LT160 User's Guide.
3) Use VERITAS NetBackup to return the drive to the up state from the down
state. If the drive cannot be returned to the up state, or if it is returned to the up
state but it soon returns to the down state again, contact maintenance personnel.
4) After all backup processing is completed, execute backup or restore again.
one medium has been selected.
If the Configuration Wizard is started from the NetBackup Assistant window to set
NetBackup, an error may occur. If an error occurs, make the settings from the
NetBackup Administration window.
When the CAS is used for insertion or ejection, be sure to mount magazine #0.
5.1 Setting VERITAS NetBackup (Solaris)
5-5