Setting A Robot Type And Drive Type - Fujitsu ETERNUS LT160 Setup Manual

Setting Backup Software
3) Execute the sg.build command to add the target settings to the
4) Execute the sg.install command to install the sg driver on the server.
5.1.3

Setting a robot type and drive type

1) Open the Media and Device Management window from the NetBackup
2) Set the robot type and drive type as follows:
5-2
cd /usr/openv/volmgr/bin/driver
/usr/openv/volmgr/bin/sg.build sg.conf -mt N -sc ./sg.conf
/usr/openv/volmgr/bin/driver/sg.conf file. Use the -mt option to specify the
maximum values for the target IDs of the LT160 controller and drive.
/usr/sbin/rem_drv sg
rm -f /kernel/drv/sg.conf
/opt/openv/volmgr/bin/driver/sg.install
*1 The sg driver is installed automatically when NetBackup is installed. When
editing the configuration definition file of the sg driver, use the rem_drv
command to delete the driver, then reinstall the driver.
Administration window, and add a robot and a drive from the Action menu on the
menu bar.
• Robot type: TLD
•
Drive type: hcart
C144-E073-01EN