Table of Contents
Advertisement
3.1.2
Connection to a server via a switch
If the tape library is connected to a server via a switch, the switch must be zoned. See
Section 3.3
Notes:
1.
2.
3.1.2.1 Connection to a single server
This section provides an example of connecting the tape library to a single server.
Server
(PRIMEPOWER, GP7000F/S, PRIMERGY )
FC SWITCH
FC Adapter
Controller
Note:
Figure 3.2 Example of connection to a single server (four drives, connected via a switch)
C144-E073-01EN
for information about zoning.
The zoning range depends on the type of connection.
If the zoning is invalid, the server cannot correctly recognize the tape library and
drives. Always perform zoning that is appropriate for the operating mode.
0
1
3
: FC Cable
2
5
7
9
3.1 Types of Connection
FC path (zoning)
3-3
Advertisement
Table of Contents
