Table of Contents
Advertisement
2) Set data for each item.
Destination Address
(To)
Sender Address
(From)
SMTP Address
(IP address)
SMTP Port
Enable Send Email
Note:
If a character other than those that can be specified is specified, an input error message is
displayed.
3) After setting data for all items, click the [OK] button.
4) A confirmation message window displaying the settings appears.
5) After processing is complete, a processing result window appears.
C144-E073-01EN
Up to five mail addresses to which mail should be sent can be
defined. Although up to 64 characters can be specified in each
text area, only one mail address can be set in the text area.
Characters that can be specified for addresses are en-size
alphanumeric characters and symbols (- _ . @). If you need to
remove an already defined mail address from the send
destinations, delete the corresponding mail address.
Specify the send source mail address. This mail address must
be the IP address defined for the SMTP server in the following
item. Up to 64 characters can be specified in the text area.
Characters that can be specified for addresses are en-size
alphanumeric characters and symbols (- _ . @).
Specify the IP address of the SMTP server used for sending
mail. Only an en-size numeric character from 0 to 255 can be
specified in each text area.
Specify the port number of the mail server, which is
normally 25.
Specify whether to enable sending e-mail to the addresses
defined above if an error occurs.
Select the check box to enable sending e-mail.
Clear the check box to disable sending e-mail.
Click the [OK] button to continue processing.
If you need to change a setting, click the [Back] button.
This completes the setting.
2.5 Setting the E-mail Function
2-5
Advertisement
Table of Contents
