Table of Contents
Advertisement
Setting the Fibre Channel Interface
2) If Hard Address is selected, specify the Loop ID.
3) A confirmation message window appears.
4) A processing-in-progress message window appears. When the processing is
3.3
Zoning
This section explains how to zone the switch using commands via telnet login to
switches.
Notes:
1.
2.
3-16
Click the numeric keypad icon and use the numeric keypad to enter data.
The Loop ID can be specified in the following range:
Loop ID: 0 to 125 (decimal notation)
After entering data, click the [OK] button.
To continue processing, click the [OK] button.
Clicking the [CANCEL] button returns to the selection window.
complete, the window changes to the end message. This completes setting of the
Loop ID.
Notes:
1.
The drive is automatically reset to allow the settings to take effect.
2.
When the drive is connected via a switch, select Soft Address for automatic
setting of the Loop ID. When the drive is directly connected, select Hard
Address to set the Loop ID.
Webtools can also be used for zoning. Refer to the "SN200 WEBTOOLS User's
Guide" for information about Webtools.
Refer to the "SN200 Zoning Guide" for information about zoning.
Numeric keypad
C144-E073-01EN
Advertisement
Table of Contents
