Preparing for Operation
Step 10. Connect the Checkout Column to the Detector
Step 10a. Connect the column to an FID or NPD
72
The instructions for connecting the column to a detector
depend on the detector type.
• For FID or NPD, see
FID or NPD"
on page 72.
• For TCD, see
"Step 10b. Connect the column to a TCD"
page 74.
• For ECD, see
"Step 10c. Connect the column to an ECD"
page 75.
The correct liner has been installed in the detector at the
factory.
1 Install a column nut and a 1.0-mm id ferrule on the column.
This may contaminate the end of the column. Prepare a fresh
column end following instructions given in
the Checkout Column"
"Step 10a. Connect the column to an
on page 49 in this book.
on
on
"Step 5. Prepare
Getting Started