Default setting (=)
Setting to will return all parameters to the standard values that were programmed at the factory.
sWhen this parameter is set to 3, is displayed for a while, then switches back to the original display
(
or
). Note that this setting also clears all trip history records. Trip history data will be cleared at
this time.
Trip clear (=)
Setting to initializes the past four sets of recorded trip history data.
* (The parameter does not change.)
Cumulative operation time clear (=)
Setting to resets the cumulative operation time monitor to the initial value (0 [zero] time).
Initialization of type information (=)
When a trip occurs because of a type error ( is displayed), you can clear the trip by setting to . This
function is used to reformat a control circuit board to adapt it to an inverter, for example, when a circuit board is
removed from an inverter to use another inverter for maintenance or for other reasons. This setting clears all type
data stored in the inverter.
Save user-defined parameters (=)
Setting to causes all the current parameter settings to be stored individually.
Reset of user-defined parameters (=)
Setting to returns all parameters to the settings saved by setting the parameter =.
* The above settings and allows you to have your own default parameter settings.
Cumulative fan operation time clear (=)
Setting to resets the cumulative fan operation time to the initial value (0 [zero] time). Set this parameter
when replacing the cooling fan, and so on.
Acceleration/deceleration time setting: 0.01 to 600.0 sec. (=)
When is set to , the acceleration/deceleration time can be set within a range of 0.01 to 600.0 sec.
Acceleration/deceleration time setting: 0.1 to 6000 sec. (=)
When is set to , the acceleration/deceleration time can be set within a range of 0.1 to 6000 sec.
5.21
Searching for all reset parameters and changing their settings
: Automatic edit function
• Function
Automatically searches for only those parameters that are programmed with values different from the
standard default setting and displays them in the user parameter group . Parameter setting can also be
changed within this group.
Note 1: If you reset a parameter to its factory default, the parameter will no longer appear in .
Note 2: It may take several seconds to display changed parameters because all data stored in the user parameter
group is checked against the factory default settings. To cancel the parameter group search in process,
press the
MODE
key.
E-43
E6581301
5