Adjustment Parameters; Pulse Train Output For Meters - Toshiba TOSVERT VF-AS1 Instruction Manual

6.35

Adjustment parameters

6.35.1 Pulse train output for meters

 : Logic output/pulse train output selection (OUT1)
 : Pulse output function selection
 : Selection of number of pulses
 : Constant at the time of filtering
 : FM output filter
• Function
Pulse trains can be sent out through the OUT1-NO output terminals.
To do so, it is necessary to select a pulse output mode and specify the number of pulses.
Set the SW4 to pulse output (PULS).
Ex.) When operations frequencies (0 to 60Hz) are put out by means of 0 to 600 pulses
=60.0, =1, =0, =600
Title
Logic output/pulse train output selection

(OUT1-NO)
Pulse output function selection

(OUT1-NO)
Selection of number of pulses

Constant at the time of filtering

FM output filter

Note 1: The pulse length is fixed. Therefore, the duty is variable.
Note 2: The minimum pulse output rate is 38 PPS. Keep in mind that no pulses can be put out at any rate smaller than 38 PPS.
Function
:Logic output
:Pulse train output
:Operation frequenc
:Operation frequency command
:Current
:DC voltage
:Output voltage
:Compensated frequency
:Speed feedback (realtime value)
:Speed feedback (1-second filter)
:Torque
:Torque command
:Torque current
:Exiting current
:PID feedback value
:Motor overload factor (OL2 data)
:Inverter overload factor (OL1 data)
:Regenerative braking resistance
:Regenerative braking resistor load
:Input power
:Output power
:A2 input
:RR/S4 input
:VI/II input
:RX input
:A1 input
:FM output
:AM output
:Fixed output 1
:Communication data output
:Fixed output 2
:Fixed output 3
:Cumulative input power
:Cumulative output power
:My function monitor 1
:My function monitor 2
:My function monitor 3
:My function monitor 4
.~.kHz
msec, msec~msec
:No filter
:Filter approx. 10ms
:Filter approx. 15ms
:Filter approx. 30ms
:Filter approx. 60ms
F-65
Adjustment range
overload factor (OLr data)
factor (percent ED)
E6581301
Default setting

6



