Toshiba TOSVERT VF-AS1 Instruction Manual page 197

Parameter setting
Positive
logic
76
78
80
82
84
86
88
90
92
94
96
98
100
102
104
106
108
110
112
114
116
7
118
120
122
124
126
128
130
132
134
136
138
140
142
Note 1: "ON" in positive logic
"OFF" in positive logic : Open collector output transistor or relay is turned off.
"ON" in negative logic : Open collector output transistor or relay is turned off.
"OFF" in negative logic : Open collector output transistor or relay is turned on.
Note 2: Alarm output check conditions are as follows.
(1) Undervoltage detected :To be checked during operation.
(2) Low current detected
(3) Overtorque detected
Sink logic/source logic
Sink logic and source logic (logic of input/output terminal) can be switched to each other.
⇒ For details, refer to Section 2.3.2.
Negative Function
logic
77 Inverter healthy output
RS485
79
communication error
81 Error code output 1
83 Error code output 2
85 Error code output 3
87 Error code output 4
89 Error code output 5
91 Error code output 6
93 Specified data output 1
Specified data output
95
2
Specified data output
97
3
Specified data output
99
4
Specified data output
101
5
Specified data output
103
6
Specified data output
105
7
107 Light load output
109 Heavy load output
111 Positive torque limit
113 Negative torque limit
Output for external rush
115
suppression relay
117 Over travel
Completion of stop
119
positioning
121 L-STOP
Power failure
123
synchronized operation
125 Traverse in progress
Traverse deceleration in
127
progress
129 Part replacement alarm
131 Over-torque pre-alarm
Frequency command 1/
133
2 selection
Failure FL (Except
135
emergency stop)
137 My function output 1
139 My function output 2
141 My function output 3
143 My function output 4
: Open collector output transistor or relay is turned on.
: To be checked during operation command.
: To be checked always.
Operation output specifications (in case of positive logic)
ON and OFF are alternately output at intervals of 1 second.
ON:Communication error occurred.
OFF:Communication error is canceled (reset).
Output the error code in 6-bit.
Output the error code in 6-bit.
Output of the designated data in 7-bit.
ON:Load is equal to  ~  set values or less.
ON:Load is larger than  ~  set value.
ON:Positive torque is over the positive torque limit level.
ON:Negative torque is over the positive torque limit level.
ON:External rush suppression relay is actuated.
ON:Over running
ON:Stop positioning has been completed.
ON:Operation at the lower limit frequency is performed
continuously.
ON:Power failure synchronized operation is performed.
ON:Traverse operation is performed.
ON:Traverse deceleration operation is performed.
Alarm:The time of replacement of parts is approaching.
ON:Over-torque is detected.
ON:Frequency command selection 2 is selected.
ON:A trip other than emergency stop has occurred.
ON:MY function output 1 is ON.
ON:MY function output 2 is ON.
ON:MY function output 3 is ON.
ON:MY function output 4 is ON.
G-8
E6581301