Installing The Drive Into The Drive Carrier - Dell VCG3C Assembly, Installation And Service Manual

Figure 32. Removing the drive from the drive carrier
Next steps
Install the drive into the drive

Installing the drive into the drive carrier

Prerequisites
1. Follow the safety guidelines listed in the
NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE: If the drive or SSD carrier has Torx screw
screwdriver to install the drive.
42 Installing and removing system components
carrier.
Safety instructions.
, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)