C
5
HAPTER
CONNECT THE ABM/REM HARNESS
NOTE:
While making the following connections, be aware of the cable routing and avoid possible cable
pinch points and other issues.
1. Plug gray 23 pin plug on the ABM/REM cable (P/N 115-0235-109) to the mating connector on the bottom of
the REM node.
2. Plug black 23 pin plug on the XRT cable to the mating connector on the bottom of the REM node.
3. Plug black 35 pin plug on the XRT cable to the mating connector on the bottom of the REM node.
4. Connect the connector labeled ABM to the AutoBoom node.
5. Use the provided 12-pin green DTM plug to protect the unused connector of the ABM node.
FIGURE 5. AutoBoom Cable Connected to Node
6. Disconnect the Bulkhead Connector 2 from port 2 on the back of the electrical box and connect it to the
BULKHEAD 2 ABM/REM Tee cable.
FIGURE 6. Installing Tee Connectors
BULKHEAD 2 Tee
Cable Teed into Port 2
34
BULKHEAD 3 Tee
Cable Teed into Port 3
Connect to
Connect to
Port 2 on
Port 3 on
Back of
Back of
Electrical Box
Electrical Box
BULKHEAD 5 Tee
Cable Teed into Port 5
Connect to
Port 5 on
Back of
Electrical Box
AGCO RoGator C AutoBoom® XRT Installation Manual