Table of Contents
Advertisement
C
3
HAPTER
MOUNT THE AUTOBOOM VALVE (IF APPLICABLE)
FIGURE 1. Machine's Hydraulic Valve Before AutoBoom Installation
Before
1. Strip the factory paint from the top of the machine's hydraulic valve using a chemical approved for paint
removal.
IMPORTANT:
Do not scrape the paint from the machine's hydraulic valve. Scraping the paint may cause damage to the
valve.
2. Remove the hydraulic test port fitting and Allen plugs from the machine's hydraulic valve.
NOTE:
The test port fitting will be installed on the AutoBoom hydraulic valve later in the procedure. Protect
the test port fitting from dust and debris to avoid contamination of the hydraulic system.
3. Clean the remaining paint from the machine's hydraulic valve, taking care to prevent paint chips from entering
the open hydraulic ports.
4. Install 9/16" ID Buna-N O-rings (P/N 219-0001-015) in the open ports of the machine's hydraulic valve.
NOTE:
Use grease or petroleum jelly to hold the O-rings in place during the AutoBoom valve installation,
taking care to avoid contamination of the inside of the open ports.
FIGURE 2. O-Rings Installed on the Machine's Hydraulic Valve
24
Allen
Plugs
Surface
to be
Stripped
Viper Pro Installation & Operation Manual
After
Advertisement
Table of Contents
