Fast Commissioning / Operating Principle; Mounting The Ams 301; Mounting The Device; Mounting The Reflector - Leuze electronic AMS 301i Manual

Fast commissioning / operating principle

3 Fast commissioning / operating principle
Notice!
Below, you will find a short description for the initial commissioning of the AMS 301i.
Detailed explanations for the listed points can be found throughout the handbook.
3.1 Mounting the AMS
The AMS 301i
plane-parallel, flat walls.
Figure 3.1:
Attention!
For error-free position measurement, there must be an unobstructed line-of-sight between
the AMS 301i
3.1.1

Mounting the device

The laser is mounted on a vertical wall using 4 screws (M5).
Alignment is performed using 2 adjustment screws. Adjust so that the laser light spot is
positioned at the center of the reflector. The alignment is to be secured with the knurled nut
and locked with the M 5 nut.
Further information can be found in chapter 5.2 and chapter 5.3.
3.1.2

Mounting the reflector

The reflector is mounted on a vertical wall with 4 screws (M 5). The reflector is angled using
the included shims. Incline the reflector by approx. 1°.
Detailed information can be found in chapter 6.4.
9
301i
and the corresponding reflector are mounted on two mutually opposing,
Schematic illustration of mounting
and the reflector.
i
AMS 301 Leuze electronic