Commissioning - Leuze electronic DB 112 B Original Operating Instructions

7

Commissioning

Note!
If the indicators flash during the initial commissioning, a calibration must first be performed
on a single sheet.
First apply operating voltage. An alignment mode is available for commissioning. This can
be used to check the alignment of the transmitter and receiver.
Alignment mode
Actuate the TEACH-IN button for > 5 s and The
Note!
After exiting alignment mode,
Leuze electronic
Green LED:
Yellow LED:
Red LED:
it is absolutely necessary to perform a calibration.
DB 112 B
and LEDs flash simultaneously at

Alignment Exiting:
ok Actuate the TEACH-IN button < 5 s
Align transmitter and receiver until
LED lights up green.
Alignment
Can only then be exited!
critical
Exceptional exiting only possible by
means of Power OFF!
Align transmitter and receiver until
LED
Alignment bad Can only then be exited!
Exceptional exiting only possible by
means of Power OFF!
Commissioning
lights up green.



9