Leuze electronic AMS 301i Manual page 40

Display and control panel AMS 301i
Warning - laser prefailure message:
LSR
Laser diode old, device still functional, exchange or have repaired.
TMP Warning - temperature monitoring:
Permissible internal device temperature exceeded / not met.
Plausibility error:
PLB
Implausible measurement value. Possible causes: light beam interruption, outside
of measurement range, permissible internal device temperature considerably
exceeded or traverse rate >10m/s.
Depending on the configuration, either zero or the last valid measurement value is
output at the interfaces.
ATT Warning received signal:
Laser outlet window or reflector soiled or fogged by rain, water vapor or fog. Clean
or dry surfaces.
Internal hardware error:
ERR
The device must be sent in for inspection.
Bar graph
Indicates the strength of the received laser light.
The center bar represents the ATT warning threshold. The distance value remains
valid and is output at the interfaces.
If no bar graph is available, the PLB status information appears at the same time.
The measurement value has thus been assessed as being implausible. Depending
on the configuration, either zero or the last valid measurement value is output at the
interfaces.
Interface info
The number "8" in the display shows the set address, the designation "RS 485" displays
the respectively activated interface.
IO1 LSR
IO2 TMP
ERR
+ 87.000 m
Position value
The measured position value is displayed in the configured unit of measurement.
+87.000 m
+87.0 in
37
PLB
8
ATT RS485
With the metric setting, the measurement value is always displayed in meters
with three decimal places.
With the inch setting, the measurement value is always displayed in inches
with one decimal place.
Address
Activated interface
Position value
i
AMS 301 Leuze electronic