Table of Contents
Advertisement
6.3
Selecting reflector sizes
Depending on system design, the reflector can be mounted so that it travels on the vehicle
or it can be mounted at a fixed location.
Attention!
The reflector sizes shown below are a recommendation from Leuze electronic for on-vehicle
mounting of the AMS 301i. For stationary mounting of the AMS 301i, a smaller reflector is
generally sufficient for all measurement distances.
On the basis of the system planning and design, always check whether mechanical travel
tolerances may require the use of a reflector larger than that which is recommended. This
applies, in particular, when the laser measurement system is mounted on a vehicle. During
travel, the laser beam must reach the reflector without interruption. For on-vehicle mounting
of the AMS 301i, the reflector size must accommodate any travel tolerances that may arise
and the associated "wandering" of the light spot on the reflector.
Overview of reflector types
AMS 301 selection
(Operating range in m)
AMS 301 40 (max. 40 m)
AMS 301 120 (max. 120m)
AMS 301 200 (max. 200m)
AMS 301 300 (max. 300m)
Leuze electronic
Recommended reflector sizes
Recommended
reflector size
...-S = self-adhesive
(H x W)
...-M = metal plate
...-H = heating
200 x 200 mm
Reflective tape 200x200-S
Reflective tape 200x200-M
Reflective tape 200x200-H
500 x 500 mm
Reflective tape 500x500-S
Reflective tape 500x500-M
Reflective tape 500x500-H
749 x 914 mm
Reflective tape 749x914-S
914 x 914 mm
Reflective tape 914x914-M
Reflective tape 914x914-S
Reflective tape 914x914-H
749 x 914 mm
Reflective tape 749x914-S
914 x 914 mm
Reflective tape 914x914-M
Reflective tape 914x914-S
Reflective tape 914x914-H
i
AMS 301
Type designation
Reflectors
Part no.
50104361
50104364
50115020
50104362
50104365
50115021
50104363
50104366
50108988
50115022
50104363
50104366
50108988
50115022
28
Advertisement
Table of Contents
