Rs 485 Address Entry - Leuze electronic AMS 301i Manual

RS 485 BUS OUT / M12 pin assignment
Schirm
(FE)
GND 485
9.3

RS 485 address entry

Notice!
Basic operation of the control panel/display is described in chapter 8.4.
To set the address parameter enabling must be activated. The display is inverted with
parameter enabling activated.
Attention!
When parameter enabling is activated, all changes made via the control panel/display are
active immediately.
9.3.1 RS 485 address entry
To do this proceed as follows:
Activate parameter enabling.
Select the RS485 submenu.
Select the address menu item.
Select the RS 485 address of the AMS
Deactivate parameter enabling.
Leuze electronic
RS 232 BUS IN (5-pin socket, B-coded)
RS 485 A
4
5
3 1 VCC 485
2
RS 485 B
M 12 socket
(B-coded)
Pin Name
1 VCC 485
2 RS 485 B
3 GND 485
4 RS 485 A
5 FE
Thread Shield
301i to be between 0 and 15.
i
AMS 301
RS 485 interface
Remark
VCC for termination
Data RS 485 B (-)
Data reference potential
Data RS 485 A (+)
Functional earth
Functional earth (housing)
48