Communicating With The Gauge - Vega FiberFlex LFXG-H Operating Instructions Manual

Terminal Block
RS-485 ground
(if applicable)
CPU board
Mounting
Bracket

Communicating with the gauge

The gauge is a transmitter that produces the current loop signal directly at the
measurement site.
Use a field communicator or HART modem and Ohmview 2000 software
with a PC to enable:
• Initial setup
• Calibration
• Other communication with the gauge
You can make a connection anywhere along the 4 ... 20 mA current-loop
line. After setup and calibration of the gauge, there are no everyday
requirements for external electronics.
LFXG-H Installation and Operation Guide
GEN2000
Introduction
Power supply board
Internal housing
ground screw
23