Checking The Gauge Repeatability - Vega FiberFlex LFXG-H Operating Instructions Manual

Procedure 3.2: To choose a linearizer type
1. Select Setup | Gauge Setup | Linearizer Type.
2. Click Table - Non-linear or Table - Linear.

Checking the gauge repeatability

Check the gauge's measurement repeatability before performing the
calibration.
To check the repeatability of the sensor, perform a data collection 3 – 4
times on the same level. If the sensor counts vary widely, you should
increase the Data collection interval parameter.
Perform a data collection to enable simple measurement of the process,
without altering the calibration or standardization values. It lets the system
measure the process and report the number of sensor counts.
LFXG-H Installation and Operation Guide
Calibration
49