Table of Contents
Advertisement
Diagnostics and repair
Some conditions are self-repairing (example: RAM and EEPROM
corruption). Therefore, these may appear in history screens but not
diagnostic screens.
Acknowledging diagnostic alarms
Diagnostic alarms turn off when the problem is solved, except these alarms:
• Source wipe due
• Shutter check due
• Standardize due
Perform the procedure to acknowledge them.
Note: If the relay is set as a diagnostic alarm, you must
acknowledge all diagnostic alarms to reset the relay.
Diagnostic alarm messages
Active alarm messages may appear on the Ohmview 2000 menu if the
alarm condition is selected. You can select individual alarm conditions in the
Alarms | Diagnostic Alarm Enable tab.
76
LFXG-H Installation and Operation Guide
Hide quick links:
Advertisement
Table of Contents
