Mounting The Bearings - DT SWISS 370 Technical Manual

Mounting the Bearings

1. Grease the bearing seats and the inner surface of
the hub shell (fig.3.2/4).
2. Slide the axle (fig.3.2/3) into the installation tool.
3. Slide the hub shell (fig.3.2/4) onto the installation
tool and the axle (fig.3.2/3).
4. Put a new bearing with the colored side outwards
onto the axle and the hub shell.
5. Put the second installation tool onto the bearing
(fig.3.2/2) and drive in the bearing using a nylon
hammer.
370 Technical Manual 19