Mounting The Manual Control Elements - DT SWISS O.L Technical Manual

Mounting the Manual Control Elements

1. Slide the spring into one of the holes.
2. Slide the second spring into the opposite hole.
3. Slide both pins onto the springs.
4. Put the rebound pin into the lockout position:
a) Put the rebound wheel onto the rebound pin.
b) Turn the rebound wheel anti clockwise until the
stop.
Caution: Do not turn the pin beyond the stop!
Otherwise the pin might stuck.
c) Turn the rebound pin clockwise 70° until you
feel a slight resistance. Don't turn beyond this
resistance.
d) Remove the rebound wheel.
5. Put on the index plate
The index points have different distances. The po-
sitioning must be like the accompanying picture.
This position must not be changed during the fol-
lowing steps.
O.L / Single Shot 2 Forks - Technical Manual 28