DT SWISS 370 Technical Manual page 40

Removing Pawls, Spring and Rotor Sealing
1. Remove the spring using a small, flat screwdriver.
2. Remove the pawls.
3. Remove the rotor sealing.
4. Check the sealing. Change a broken sealing.
Dismounting the Ring Nut
The ring nut has only to be replaced, if it is damaged.
The bearing on the drive side can also be changed when the ring nut is still mounted.
The ring nut gets tightened while pedaling. Because of this it might be very hard to loose the ring
nut. It is recommended to loosen the ring nut only when the wheel is complete.
1. Put the tool for the ring nut in the clamp in its
high position.
2. Put the drive side of the hub onto the tool.
3. Turn the wheel, respectively the hub anti clock-
wise.
370 Technical Manual 39