Cleaning And Degreasing All Parts; Mounting Bearings And Axle - DT SWISS 240 OVERSIZE Technical Manual

3.5 CLEANING AND DEGREASING ALL PARTS

Clean all parts of the hub (see "Cleaning" on page 4)

3.6 MOUNTING BEARINGS AND AXLE

1. Slightly grease the seating of the bearings and
the inner surface of the hub shell using universal
grease.
2. Put the axle onto the installation cylinder.
3. Put the drive side of the hub shell onto the
installation cylinder and the axle.
4. Slightly grease the bearing and put it onto the non
drive side with the colored side facing outwards.
10