Mounting The Adapters - DT SWISS 370 Technical Manual

6. Turn the hub 180° an repeat steps to drive in the second bearing.
7. Check the play of the hub. Therefore hold the axle
and move the hub axial.
> The hub must not have play.
8. If there is play, drive in the bearing.
If you are using a disc-brake-hub, drive in the bea-
ring on the disc-side first.
9. Check the running of the bearings. Therefore hold
the axle and turn the hub.
> The hub must turn smoothly.
10. If the hub turns stiff, slightly loosen the bearings
by hitting the axle with slight hammer strokes.
If you are using disc brake hubs, first loosen the
bearing on the non disc-side.

Mounting the Adapters

1. Grease the bearings and the inner surface of both
adapters (fig.3.2/1).
2. Put the adapters (fig.3.2/1) onto the hub by hand.
Closing Steps
not required
370 Technical Manual
Link
20