DT SWISS 370 Technical Manual page 31

Mounting the Bearing
1. Put a new bearing (fig.3.3/13) with its colored side
outwards onto the bearing shell (fig.3.3/12).
2. Put the short installation tool onto the bearing
(fig.3.3/13).
3. Drive in the bearing using a nylon hammer.
4. Take the axle (fig.3.3/4) out of the hub, turn it
180° and put it back into the hub.
5. Put the drive side of the hub onto the long instal-
lation tool.
6. Put a new bearing (fig.3.3/3) with its colored side
outwards onto the axle.
370 Technical Manual 30