DT SWISS 370 Technical Manual page 29

Mounting the Pawl Carrier
1. Grease the bearing seats and the inner surface of
the hub shell.
2. Put a 12 mm Allen key into a vice.
3. Put the screw fitting (fig.3.3/5) onto the Allen key.
4. Put the hub shell (fig.3.3/6) onto the screw fitting.
5. Put the pawl carrier (fig.3.3/8) into the hub shell
(fig.3.3/6).
6. Turn the wheel (or the hub shell) clockwise and
tighten the screw fitting with a min. torque of
60 Nm.
7. Remove the hub and the Allen key from the vice.
370 Technical Manual 28