Mounting The Release Mechanism - DT SWISS D 232 Technical Manual

MOUNTING THE RELEASE MECHANISM

Required Material
D232 LATCH SYSTEM KIT Art. No.: DWKD232X30510S
universal grease
*The service kit only needs to be replaced if there is a seat post malfunction (see "Trouble Shooting"
on page 14). In case of malfunction, all parts of the required service kit should be replaced.
1. Grease the guide, spring, release piston and
inner surface of the seat tube.
2. Insert the guide, spring and release piston
into the seat tube.
3. Push the stop for the release piston into the
seat tube and tighten the stop with an 8 mm
hex key to a torque of 4 Nm.
→ The recess of the stop must point
upwards.
4. Place the raster ring on the seat tube.
→ The chamfered side of the raster ring
must point upwards.
32
Specification
Details, see "Service and care" on page 13
Slick Honey
Quantity
1*
as required