DT SWISS 370 Technical Manual page 14

7. Turn the hub 180°.
8. Slide the spacer (fig.3.1/4) with the o-rings
(fig.3.1/5) into the hub.
9. Put a new bearing (fig.3.1/3) with the colored side
outwards onto the bearing seat.
10. Put the installation tool into a vice.
11. Slide the disc-side of the hub shell onto the tool.
12. Put the second installation tool onto the non disc-
side of the hub shell.
13. Drive in the bearing (fig.3.1/3) using a nylon ham-
mer.
370 Technical Manual 13