DT SWISS 370 Technical Manual page 33

Mounting the Needle Cage, the Pawl and the Spring
1. Grease the needle cage (fig.3.3/11) and the need-
les using universal grease.
2. Grease the bearing shell (fig.3.3/12), the inner sur-
face of the hub shell, the axle and the thread
using universal grease.
3. Slide the needle cage (fig.3.3/11) onto the hub and
attach the needles using forceps (or s.th. similar).
4. Check if all needles are attached correctly inside
the needle cage.
5. Attach both pawls (fig.3.3/9).
Grease the pawls generous. This way, the pawls
stuck in the correct position.
370 Technical Manual 32