DT SWISS 370 Technical Manual page 30

8. Put the long installation tool into the vice.
9. Put the long side of the axle (fig.3.3/4) into the in-
stallation tool.
10. Slide the hub shell onto the tool and the axle.
11. Screw the bearing shell (fig.3.3/12)onto the pawl
carrier (fig.3.3/8) by hand.
12. Put the wrench for the bearing shell onto the bea-
ring shell (fig.3.3/12).
13. Screw on the bearing shell using a 27 mm wrench.
Caution: Left-hand thread.
370 Technical Manual 29