Removing The Adapters, Rotor And Rotor Sealing - DT SWISS 370 Technical Manual

Required Material
service kit ONYX/CERIT
needle cage kit
spring for pawl carrier
ball bearing drive side
ball bearing non drive side

Removing the Adapters, Rotor and Rotor Sealing

1. Clamp the axle opposite to the rotor-side into the
axle holder.
2. Unscrew the knurled disc (fig.3.3/1) on the rotor
side using a 17 mm wrench.
3. Remove the knurled disc (fig.3.3/1) and the adap-
ter (fig.3.3/15).
4. Carefully slide the rotor (fig.3.3/14) off the hub.
Specification
includes spring for pawl carrier, two
pawls, universal grease, see
includes needle cage and 12 needles, see
chap.4, p.47
see chap.4, p.47
see chap.4, p.47
see chap.4, p.47
370 Technical Manual
Amount
as required
chap.4, p.47
as required
1
1
1
22