Mounting The Bearings - DT SWISS 370 Technical Manual

Mounting the Bearings

1. Grease the bearing seats and the inner surface of
the hub shell (fig.3.1/6).
2. Put a new bearing (fig.3.1/3) with the colored side
outwards onto the bearing seat on the disc-side.
3. Put the installation tool into a vice.
4. Slide the non disc-side of the hub shell onto the
tool.
5. Put the second installation tool onto the disc-side
of the hub shell.
6. Drive in the bearing using a nylon hammer.
370 Technical Manual 12