Setting The Margin Position; Setting The Cut Position; Setting The Dispense Position - Avery Dennison ADTP1 System Administrator Manual

Setting the Ma rgin Position
This function adjusts where the format prints side to side on the supply. The adjustments
are in dots where one dot equals 0.0049 inch.
The width of the print area depends on the supply size. The maximum width is four
inches. When you move the image to the right or left on the supply, avoid moving the
image too close to either edge, because it may not print.
Pr in t t oo far t o t he l eft
Changing this setting only affects new formats sent to the printer. Any formats previously
saved into flash memory are not affected.
Select To
Decrease the setting. Moves print to the left.

Increase the setting. Moves print to the right.

Press 1 to toggle the amount (1, 10, or 100).

Setting the Cut Position

This function adjusts where the tag is cut. The printer adjusts the cut position according
to the index marks on the supply. Aperture supplies may need adjustments. Increase to
move the cut up; decrease to move the cut down.
Select To
Decrease the setting. Moves the cut down.

Increase the setting. Moves the cut up.

Press 1 to toggle the amount (1, 10, or 100).
Setting the Dispe nse Position
This function adjusts the amount to advance each label to allow for easy removal from the
printer.
Select To
Decrease the setting. Moves the print down.

Increase the setting. Moves the print up.

Press 1 to toggle the amount (1, 10, or 100).
2-8 System Administrator's Guide
Pr in t t oo far t o t he ri ght
Classification: Avery Dennison - Public