09/09 Rev. 5.03-01
Options
The optional features – with the exception of the foot switch – can only be in-
tegrated into the AP 5.4.
Internal Options
...should be factory-fitted or installed by a service engineer:
External Options
...do not require any special alterations to the printer, however, the printer
must be prepared for the use of peripheral devices:
USER / SERVICE MANUAL
AP 4.4 – AP 5.4
•
Reflex Sensor Kit: Light barrier fitting that apart from the transmission sen-
sor, also contains a reflex sensor.
•
Label sensor for short labels. Recommended for label length < 30 mm.
•
Internal rewinder kit: To retrofit the internal rewinder; contains the rewinder
as well as the driver board and material guide
•
I/O board: RS- 422/485 interface, signal interface
•
Contact brush for narrow label web (< 30 mm); recommended for AP 5.4
with „Rewinder 2000".
•
Cutter
•
Rewinder for material rolls with 38 mm (1.5"), 75 mm (3") or 100 mm (4")
cores („Rewinder 2000")
•
Keyboard for offline operation
•
Foot switch for foot-operated label dispensing (printer must additionally be
equipped with an I/O board)
•
Dispensing edge (only for dispensing versions)
3
Specifications