Setting The Feed Mode; Setting The Cut Mode - Avery Dennison ADTP1 System Administrator Manual

S e t t i n g t h e F e e d M o d e
Set the feed mode based on your application and supply type. To load supplies for liner
take-up, refer to the Operator's Handbook.
Select
Continuous
On-Demand
Liner Take-up
S e t t i n g t h e C u t M o d e
Set how the printer cuts tags. Purchase the optional 933 Cutter. The supply may shift as
the cutter cuts and you may see a small disruption on the printed supply. This shift does
not affect bar code quality. There is no cut button on the printer – select the appropriate
cut mode for your application.
Since the cutter is 3.4 inches away from the printhead, printed tags may be left between
the printhead and cutter. The cutter operates when the printer is running. If the printer is
paused, the cutter stops cutting. The cutter also stops cutting whenever the cutter's
cover is opened.
When cutting RFID supplies, enable tag saver.
Description of cut modes:
Cut Mode
first tag in Batch?
Disabled
No Cut
Cut Each T ag
Cut Each Batch
Cut Mode 3
Cut After Last
T ag
Cut Mode 4
No Cut Before
Cut Mode 5
Cut Last Strip
Cut Mode 6
Cut After Batch
No* Cut Modes 3 and 5 minimize the number of tags left between the printhead and
the cutter. Depending on the length of supply being cut, there may be one tag
left between the printhead and the cutter.
Yes* The last tag in the batch is queued to be cut once it reaches the cutter; however,
there may be printed tags left between the printhead and the cutter. The user
must send another batch to feed the last tag out far enough to be cut.
To
Print tags or labels in one strip.
Print one label, once that label is removed, the next label prints.
Print labels while the liner is collected on a take-up reel inside the
printer. This is optional.
Cut Before
No
Yes
Yes
Yes
No
Yes
No
Classification: Avery Dennison – Public
Cut Between Cut After
T ags? Batch?
No No
Yes Yes
No Yes
(Feeds strips)
Yes Yes
Yes Yes
No Yes
(Feeds strips)
No Yes
Printed tags left between
printhead and cutter?
No
Yes*
Yes*
No*
Yes*
No*
No
Setting Supply Options 2-5