Replacing The Spin-On Air/Oil Coalescer - Vanair Air N Arc All-in-One Power Systems 300 Operations Manual & Parts List

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
1. With the machine off and the ignition key
removed, place a suitable receptacle under
the compressor drain tube [A] and remove
the drain cap [B].
2. After oil has completely drained, securely
replace the drain cap [B].
3. Replace the oil filter (see Section 6.5.4 for
instructions on how to replace the
compressor oil filter element).
4. Replace the air/oil coalescer (see Section
6.5.6 for instructions on how to replace the
spin-on air/oil coalescer filter).
5. Once the oil filter and air/oil coalescer have
been replaced, remove the compressor oil fill
cap/dipstick [D], and fill the compressor unit
to the service capacity level (two [2] quarts)
with Vanguard™ Premium Synthetic Oil.
Only Use Vanguard Premium Synthetic
6. Run the compressor momentarily, turn off,
and verify the level of compressor oil [E].
6.5.6 REPLACING THE SPIN-ON AIR/OIL
COALESCER
The air/oil coalescer element is a spin-on disposable
type. Consult Figure 6-7, and use the following
procedure to replace the coalescer element. Consult
Section 6.3, Maintenance Schedule Table for routine
coalescer element change intervals.
TOOLS NEEDED
Strap Wrench
Compressor Oil (to
coat seal)
1. With the machine off and the ignition key
removed, open the hood panel.
2. Locate the spin-on element situated on the
topside at the rear of the compressor unit.
3. Remove the old element by turning
counterclockwise using a strap wrench.
IMPORTANT
Oil.
REPLACEMENT
PART(S)
Coalescer Replacement
Element No. 264154-109
090010-OP_r0
®
DO NOT overfill the compressor system;
stay within the recommended guidelines
as prescribed in Section 3, Table 3B:
Specifications - Air Compressor.
For extreme weather conditions, refer to
Figure 6-7: Air/Oil Coalescer Element
SECTION 6: MAINTENANCE
NOTE
NOTE
Section 6.7.
PAGE - 73