Vanair Air N Arc All-in-One Power Systems 300 Operations Manual & Parts List page 89

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
C
A
1. With the machine off and the ignition key
removed, open the hood panel access door.
2. Locate the compressor oil filter, coming off the
top of the oil cooler.
3. Remove the worn oil filter element [A] by
turning it counterclockwise using a strap
wrench.
4. Clean the filter head [B] with a lint-free wiper
or cloth. NOTE: If filter head needs to be
removed, make certain the outlet [C] and
inlet [D] coincide with the oil flow direction
[E].
5. Apply a light film of compressor oil to the
element's [A] sealing surface for an air-tight
seal between the element and the filter head
[B].
6. Install the new element [A] by manually
turning it clockwise onto the filter head [B]
until the seal contacts the machined groove
on the rim of the filter head. Then turn an
additional 3/4 of a turn, using a strap wrench
if necessary.
7. Run the compressor and check for leaks.
8. Dispose of discarded filter within the
guidelines of all applicable local, regional
and/or federal laws.
D
E
B
Figure 6-5: Compressor Oil Filter Element
090010-OP_r0
®
KEY
A OIL FILTER ELEMENT
B OIL FILTER HEAD
C OUTLET END OF FILTER HEAD
(MARKED)
D INLET END OF FILTER HEAD
(MARKED)
E OIL FLOW DIRECTION
If the oil filter element head needs to be
replaced, it must be situated to allow for
proper flow, as per Figure 6-5. DO NOT
install the filter element head in reverse
SECTION 6: MAINTENANCE
DESCRIPTION
NOTE
direction.
PAGE - 71