Replacing The Engine Oil - Vanair AIR N ARC RELIANT 250 Series Operations Manual & Parts List

All-in-one power systems
Table of Contents

Advertisement

®
AIR N ARC
200 SERIES ALL-IN-ONE POWER SYSTEM
range between F (full) and L (low) on the
gauge [ G
If the level shows low, replenish with the same type of
engine oil currently being used to achieve a satisfactory
level, by adding oil at engine oil fill port [ B ].
If the engine is due for an oil change, or if operating
conditions require more frequent change intervals than
the normal routine maintenance schedule given in this
section, consult the Engine Operator's Manual for oil
change scheduling, and the procedure on how to change
the engine oil.

6.5.9.3 REPLACING THE ENGINE OIL

TOOLS NEEDED
Clean Cloth
Funnel
Drain Pan
Catch Pan
Disposable Container
Oil Filter Strap
Wrench
I
Consult Engine Operator's Manual for oil grade used,
amount needed, and oil change intervals. Engine Capacity
is two (2) quarts (system), 1.75 (service).
Refer to Figure 6-21 . Replace the oil filter at least every
other oil change (every 200 hours of operation).
Always use a genuine Kohler
filter as follows:
1. To keep dirt, debris, etc., out of the engine,
clean the area around the dipstick [ A ];
remove the dipstick.
2. Remove the oil drain plug [ F ], and let the oil
drain into a receptacle container such as an
automotive oil pan. Allow ample time for
complete drainage.
3. Reinstall the drain plug [ F ] and torque to 13.6
Nm (10 ft-lb.).
4. To keep dirt, debris, etc., out of the engine,
clean the area around the oil filter [ C ];
remove the oil filter.
5. Wipe the surface with a clean cloth where the
oil filter mounts.
and G
].
1
2
REPLACEMENT
PART(S)
Engine Oil
Engine Oil Filter
Replacement Element
No. 270757
®
oil filter. Replace the oil
090019-OP_r0
®
Relieve pressure from the compressor
system before performing maintenance
Before performing maintenance or repair
operations on the machine, ensure that
all power has been removed and locked
out to prevent accidental start-up.
I
SECTION 6: MAINTENANCE
WARNING
on any components.
WARNING
PAGE - 93

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents