Instrument Panel - Dc Charger (12V Boost) Function - Vanair Air N Arc All-in-One Power Systems 300 Operations Manual & Parts List

APPENDIX B: INSTRUMENT PANEL FUNCTIONS
B.4.3 INSTRUMENT PANEL - DC CHARGER (12V BOOST) FUNCTION
A
FUNCTION/ACTION
1 DC Welder/Charger
switch is in DC Char-
I
ger position
2 DC Charger Mode
switch is in the 12V
Boost position
I
When DC Welder/Charger selector switch is in DC Charger position, all Weld mode controls will be
ignored including the amperage control.
II
The "On" function for a running system refers to the reverted condition of the ignition switch after the
engine has completed starting, as per Section B.2.4, Key to Run Function.
NOTE: All other LEDs will be off.
PAGE - 174
1
D
SUSTAINED OR RESPONSE CONDITION
A Hour meter constantly displays total hours; fuel level meter con-
tinues to display.
B The ignition position is ON, with the engine operating in low
idle.
12V Boost DC Charger Mode LED is lit.
II
C
D Volt LED will be on; display will indicate the programmed
charge voltage for the indicated mode.
090010-OP_r0
®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
2
C
®
IMPORTANT
Boost function is
used only for start
assist. Sustaining
boost can damage
equipment.