Section 5: Operation; General Information - Vanair Air N Arc All-in-One Power Systems 300 Operations Manual & Parts List

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM

SECTION 5: OPERATION

5.1 GENERAL INFORMATION

The Air N Arc 300 All-In-One Power System has a
comprehensive array of controls and indicators for each
function of the power system. Understanding the correct
operation of the 300 Series system will help you to
understand and recognize when the system is operating
optimally. The information in the Operation Section will
help the operator to recognize and interpret the readings,
which will call for service or indicate the beginning of a
malfunction.
System Operation Group
Engine Start-up and Shutdown Pro-
cedure
Engine Start-up
Engine Shutdown
Engine Throttle Control Functions
Operating the Welder
Welder Operating Procedure
CC (Constant Current) Mode
CV (Contant Voltage) Mode -
Using a Voltage Sensing Suit-
case Feeder
CV (Contant Voltage) Mode -
Using a Spool Gun
Operating the Generator
Operating the Air Compressor
Operating the Battery/Boost Char-
ger
Connection - Disconnection
Sequence and Operation
®
Manual Location
Section
5.2 page 46
page 47
5.2.1
page 47
5.2.2
page 48
5.3
5.4 page 49
5.4.1 page 49
5.4.1.1 page 49
5.4.1.2 page 50
5.4.1.3 page 51
5.5 page 52
5.6 page 53
5.7 page 54
5.7.1 page 55
090010-OP_r0
SECTION 5: OPERATION
WARNING
Before starting, performing maintenance,
or replacing parts, relieve the entire
system pressure by opening the air tank
drain/vent valve, which will vent all
pressure to the atmosphere.
WARNING
Before performing maintenance or repair
operations on the compressor, ensure
that all power has been removed and
locked out to prevent accidental start-up.
WARNING
Follow all applicable safety
recommendations as outlined in Section
1: Safety of this manual.
NOTE
Before starting the Vanair
All-In-One Power System, read this
section thoroughly and familiarize
yourself with the controls and indicators
- their purpose, location and use.
NOTE
If any of the compressor, generator or
welder switches are set to ON prior to
starting, the machine will start at full
speed.
®
Air N Arc 300
PAGE - 45