Section 4: Operation; Machine Package Receipt/Inspection; Machine Package Prep; Service Body Prep - Vanair Air N Arc All-in-One Power Systems 300 Operations Manual & Parts List

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
SECTION 4: INSTALLATION
4.1 MACHINE PACKAGE RECEIPT/
INSPECTION
Upon receipt of the machine package, inspect the
exterior of the shipping crate for signs of shipping/transit
damage. Any damage should be reported immediately to
the shipping company. Open the lid and inspect the
component parts and supports to ensure that there has
been no internal
components which may have caused damage. To install
the 300 Series All-In-One Power System, refer to the
following sections:
System Component or
Part Group Task

Machine Package Prep

Service Body Prep

Machine Package Mounting
Installation and Dimensions Dia-
gram (Part 1 of 2)
Installation and Dimensions Dia-
gram (Part 2 of 2)
4.2 MACHINE PACKAGE PREP
Refer to Figure 4-1 and Section 4.5, Installation and
Dimensions Diagram, and the following instructions.
1. Remove packing and inspect the machine
and control panel for shipping damage.
2. Check fluid levels, if needed. Refer to Section
6.5.3 for compressor oil, and Section 6.5.13
for engine oil.
4.3 SERVICE BODY PREP
Consult Section 3, Specifications for dimension
requirements, and the following instructions.
®
movements of assemblies
Manual
Location
Section
4.2 page 37
4.3 page 37
4.4 page 39
4.5 page 42
4.5 page 43
090010-OP_r0
SECTION 4: INSTALLATION
DANGER
DO NOT install in enclosed spaces.
WARNING
or
ELECTRICAL HAZARD! Be sure the
battery is disconnected before starting
the installation.
NOTE
Contact Vanair at
(219) 879-5100 / (800) 526-8817
Service Fax: (219) 879-5335
www.vanair.com
to report missing items, incorrect part
numbers, or other discrepancies.
NOTE
Install electrical components (circuit
breakers, pressure switches, toggle
switches, etc.) in locations where
exposure to water or moisture will be
most minimized.
NOTE
In order to prevent accidental damage to
vehicle components (fuel tanks, lines,
brake lines, wiring harnesses), note their
location before drilling any holes.
PAGE - 37