Repairing The Air Inlet Valve - Vanair Air N Arc All-in-One Power Systems 300 Operations Manual & Parts List

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
4. Seat a new filter element [B] into filter/inlet
valve housing [D].
5. Replace cover [C] and wing nuts [A].
6. Close the hood.
7. Dispose of discarded filter within the
guidelines of all applicable local, regional
and/or federal laws.

6.5.2 REPAIRING THE AIR INLET VALVE

Should a condition occur that requires air inlet valve
maintenance (see
Guide), a repair kit is available. To repair the air inlet
valve, order air inlet rebuild kit no. 264154-101. Refer to
Figure 6-3, and the following procedure:
TOOLS/ITEMS NEEDED
Hex Head Screwdriver
or Wrench
Adjustable Wrench
1. Shut down machine and lock out all power, as
per the Safety Section of the manual.
2. Locate the compressor's air filter
compartment housing and remove the three
(3) wing screws [A] from cover [C].
3. Remove air filter [B], and put it aside
temporarily so it will not get damaged or
soiled; the full air filter inlet valve [D] is now
accessible.
4. Remove the two (2) cylinder head screws [E].
5. Grasp the valve [D] and pull upwards to
disengage the valve from its valve seating.
6. Disassemble the valve and replace used
parts with new parts found in the kit. Refer to
Figure 6-3 to assure correct replacement
and part position.
Use all of the parts provided in the kit
regardless of the old part condition.
7. Once the valve's parts have been replaced
with the kit parts and re-assembled, place
the rebuilt, complete inlet valve assembly
back into position on the valve seating within
the air filter housing.
®
Section 7.2, Troubleshooting
REPLACEMENT
PART(S)
Air Inlet Filter
Rebuild Kit No.
264154-101
NOTE
090010-OP_r0
SECTION 6: MAINTENANCE
PAGE - 67