Vanair Air N Arc All-in-One Power Systems 300 Operations Manual & Parts List page 105

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
these settings. For such cases, consult Figure 6-15, and
the following procedure:
TOOLS NEEDED
Screw Driver
There must be a
difference between the cut-in and cut-out
pressures for the system to operate
1. Locate the air pressure control switch [B] at
the right of the battery bracket [A]. Remove
the cover retaining screw [D] fastening the
cover to the switch, and remove the cover
[C].
A
KEY
A BATTERY BRACKET
B PRESSURE SWITCH
C PRESSURE SWITCH COVER
Figure 6-15: Pressure Switch Adjustment for Cut-in / Cut-out Pressure Settings
REPLACEMENT
Not Applicable
NOTE
minimum of 25 psi
properly.
B
C
D
DESCRIPTION
090010-OP_r0
®
Pressure settings (both minimum and
maximum) are pre-secured within the
PART(S)
rated capacity levels for this machine at
the factory before shipping. However, it
may be necessary to manually adjust.
NEVER adjust the pressures beyond the
recommended or rated capacity
KEY
D COVER RETAINING SCREW
E COMPRESSOR CUT-IN PRESSURE
ADJUSTMENT
SECTION 6: MAINTENANCE
WARNING
specified for the machine.
E
DESCRIPTION
PAGE - 87