Compressor Air Filter Inspection; Compressor Air Filter Replacement - Vanair Air N Arc All-in-One Power Systems 300 Operations Manual & Parts List

SECTION 6: MAINTENANCE
WARNING
Relieve pressure from the compressor
system before removing any
components.
A
KEY DESCRIPTION
A LIGHT SHINING THROUGH PIN-
HOLES INDICATES A WORN
FILTER ELEMENT
B TYPICAL LIGHT SOURCE
PLACED WITHIN FILTER TO
SHINE OUTWARD
Figure 6-2: Air Filter Inspection
PAGE - 66
AIR N ARC
6. Replace cover [C] and wing nuts [A].
7. Close hood.

6.5.1.2 COMPRESSOR AIR FILTER INSPECTION

Consult Figure 6-2 and the following procedure to
inspect the compressor air filter
TOOLS/ITEMS NEEDED
Light source
1. Place a bright light source inside of the filter
2. Inspect the gaskets on the top and bottom of
B
3. Replace the element if it shows any damage
6.5.1.3 COMPRESSOR AIR FILTER
REPLACEMENT
The air filter element uses a pleated paper-type filter to
carefully
compression can begin. DO NOT clean the compressor
air filter element.
TOOLS/ITEMS NEEDED
Container large enough
to accommodate filter
To replace worn or damaged air filter with new filter,
consult Figure 6-1, and the following procedure:
1. With the machine off and the ignition key
2. Remove three (3) wing nuts [A] from the air
3. Remove old air filter element [B] from air filter
090010-OP_r0
®
300 SERIES ALL-IN-ONE POWER SYSTEM
.
element and carefully inspect the filter from
the outside in a dark environment to detect
any pinholes or tears that may have
developed.
the air filter for any damage or wear.
or wear even if the inspection occurs before
the recommended replacement interval.
Consult Section 6.5.1.3 if filter needs to be
replaced.
remove accumulated
removed, open the hood panel and locate
the compressor air filter.
filter/inlet valve cover [C] on the top of the
compressor unit.
housing [D].
®
REPLACEMENT
PART(S)
Not Applicable
dirt before being
REPLACEMENT
PART(S)
Air Filter Element
No.
264154-095