Connection - Disconnection Sequence And Operation - Vanair Air N Arc All-in-One Power Systems 300 Operations Manual & Parts List

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
and can only be adjusted by authorized factory
personnel.
During charging, if the machine begins to cycle between
high and low idle, then hte battery is fuly charged.
5.7.1 CONNECTION - DISCONNECTION SEQUENCE
AND OPERATION
Never attach boost cables to the panel
before attaching to the battery. Always
attach cables to the battery first.
1. With the engine off, insure that the welder, DC
charger switch, and any other engine control
switch is in the OFF position.
2. Attach the clamps of the battery charge cable
to the battery to be charged. RED to the
positive terminal, BLACK to the negative
terminal (Figure 5-5).
3. Plug the battery charge cables into the battery
cable connection.
4. Start the engine and wait for all indicator lights
to turn off. Place the DC Welder/Charger
selector toggle switch in the DC Charger
position, and then the DC Charger Mode
switch to the correct position. The engine
should come up to operating speed; the
battery is being charged.
5. When machine begins to cycle between high
and low idle then the battery is fully charged.
6. To disconnect the charging system, place the
DC Welder/Charger selector toggle switch to
the OFF position.
7. Allow engine to idle down, then shut down the
engine.
8. Now it is safe to disconnect the clamps from
the battery being charged, and the battery
cable connection on the front of the machine.
IMPORTANT
090010-OP_r0
®
KEY
A
B
Figure 5-5: Battery Cable
SECTION 5: OPERATION
A
B
DESCRIPTION
BLACK
RED
Connections
PAGE - 55